FAQ
- Q1 Can I use this unit with a USB bus power not using an AC adapter?
-
A1
No. The DDJ-REV7 isn't USB bus powered. Ensure to connect the supplied AC adapter to the unit.
Net Number : 42 - Q2 Can I connect the unit using a conversion cable?
-
A2
We don't guarantee that a conversion cable will work properly.
Net Number : 43 - Q3 The fader knob is too hard to pull off.
-
A3
The unit has P-LOCK Fader Caps which stop the knobs slipping off the channel fader and crossfader knobs.
They may break if you pull them too hard so please be careful.Net Number : 44 - Q4 Is the BOOTH terminal TRS or TS? What are its polarities?
-
A4
TRS.
TIP=HOT, RING=COLD, and SLEEVE=GND.Net Number : 45 - Q5 Which output terminals are balanced?
-
A5
The following output terminals are balanced:
[MASTER OUT 1] terminal (XLR)
[BOOTH OUT] terminal (TRS)Net Number : 46 - Q6 Is the microphone (MIC) input terminal TRS or TS? What are the polarities?
-
A6
TRS.
See the figure below for the polarities as seen from the front of the terminal.
Net Number : 47 - Q7 Does the microphone (MIC) input terminal support phantom power supply?
-
A7
No. Phantom power supply isn't supported.
Net Number : 48 - Q8 Can I use a stereo microphone?
-
A8
No. Please use a mono microphone.
Net Number : 49 - Q9 Can I replace the crossfader with one from another brand?
-
A9
We don't offer repairs on crossfaders made by other companies.
If you replace the crossfader with one from another brand, your warranty will become invalid.Net Number : 50 - Q10 How can I replace the slip sheets?
-
A10
If you want to replace the slip sheets with those of a different material, replace the installed slip sheets (there are 2 in each jog wheel, double-stacked) with the slip sheets of your choice.
– Suitable slip sheet size: Outer diameter 175 mm, inner diameter 135 mm, total thickness less than 1.6 mm
– Recommended number of slip sheets: 2
The slip sheet is an important part for the rotation of the top plate, so be sure to handle it with care.Net Number : 54